Configuring with COM 115F
Starting COM 115F CONFIGURE
Make sure that all the COM 115F files you require are either
- on the hard disk of your programmer or
- on the diskette in your programmer drive.
Start the S5 command interpreter by pressing S5 <CR>.
A list of all the STEP 5 packages available on diskette or hard disk will then appear.
Select the desired package with the cursor control keys:
- COM 115F CONFIGURATION
Confirm your selection with the F1 "PACKAGE" key.
The "Defaults" screen form will appear.
DEFAULTS
CPU 9427UF...: 15
SYMBOLS
FOOTER
PRINT WIDTH
OP MODE
PATH NAME
Status:
SPECIFICATION OF TYPE
F1
Completing the Defaults screen form
The following is the minimum information you must enter in the Defaults screen form:
•
Program file name in which your entire configuration data will be stored.
•
The last two digits of the CPU descriptor
•
The operating mode for online or offline programming.
Key assignments for the Defaults form:
Cursor keys
The double-arrow keys < > or < > move the cursor to the right or left of
the screen and the single-arrow keys < >, < >, < >, < > move the
cursor to the input fields.
F3 (SELECT)
Shows the choices at the cursor position.
1-6
PROGRAM FILE
: NO
SYMBOLS FILE
: NO
FOOTER FILE
: SMALL
PRINTER FILE
: OFF
:
PATH FILE
F2
F3
F4
SELECT
Figure 1-2. The COM 115F Defaults Screen Form
COM 115F / PDC15
: B:@@@@@@ST.S5D
:
:
:
:
F5
F6
F7
EXEC
S5-115F Manual
F8
EWA 4NEB 811 6149-02