Initialization Form For Analog Modules - Siemens SIMATIC S5 Manual

Configuring with COM 115F
In the case of analog modules, the input/output word is located on the left side of the I/O type
configuration field window and the type number on the right side.
I/O words 128 to 254 are listed vertically.
S5-115F: Configuring the I/O Modules
I/O word
AI word
AI word
Analog input 0
Static type characteristics
Status: TYPE INPUT
F1 F2
SEARCH COPY
You can use the cursor control keys to position the cursor anywhere within the configuration
menu.
If you exceed the bottom right edge of the matrix, the matrix is scrolled up and if you exceed the
top left edge, the matrix is scrolled down.
I/O type configuration field
The I/O type number is entered at the cursor position and confirmed with <CR>.
A check is made after the entry of every type number and, in the event of an error, the message
"WRONG TYPE"
appears.
When a valid type has been entered, the cursor jumps to the characteristics field and from there
returns to the next type matrix field.
You can overwrite a type already entered. Use the space key to delete a type.
The I/O type number depends on the I/O module and on the characteristics of the particular signal.
The following relationship applies:
Digital inputs:
Digital outputs:
Analog inputs:
Analog outputs:
1-30
128
130
Type characteristics to be configured
by the user
F3 F4
SWAP DELETE TYPES
Figure 1-20. Initialization Form for Analog Modules
TYPE 1 to 3
TYPE 8 to 10
TYPE 13 to 16
TYPE 18
COM 115F / PDC15
Type number
F5 F6 F7
SAVE
S5-115F Manual
I/O type
configuration
fields
Characteristics
field
F8
RETURN
EWA 4NEB 811 6149-02