Programmers And Personal Computers Suitable For Com 115F - Siemens SIMATIC S5 Manual
Hide thumbs
Also See for SIMATIC S5:
- Manual (360 pages) ,
- Equipment manual (197 pages) ,
- Operating instructions manual (43 pages)
Table of Contents
Advertisement
Configuring with COM 115F
COM 115F programs run on the following programmers and personal computers:
Table 1-3. Programmers and Personal Computers Suitable for COM 115F
Programmers
PG 635
PG 685
PG 695
PG 710
PG 720
PG 730
PG 740
PG 750
PG 770
The S5-DOS operating system must be available on all systems.
Generating a working copy of the diskettes supplied
First, make a working copy of the diskettes supplied and then keep the original software in a safe
place.
Copy the COM 115F programming software from diskette to hard disk:
Load the PCP/M86 operating system
Insert the diskette in drive A
Copy the contents of the diskettes to user area 0 of the hard disk (drive B)
e.g.:
Type in B>USER 0 and press <RETURN>
Type in B>PIP B:=A: * . * and press <RETURN>
If necessary, assign the attributes [RO] and [SYS] to the copied files
e.g.:
B>SET * . * [RO SYS]
The attribute [RO] protects the files from being overwritten. The attribute [SYS] allows the
files to be accessed from all user areas.
The program section of COM 115F contains the following packages:
•
COM 115F CONFIGURE for
-
Entering the configuration data in the programmer
-
Printing out the configuration data
•
COM 115F DOCUMENT for
-
Safety-oriented readout of the configuration data from the programmable controller
-
Printing out the data in the programmable controller
Note
The printout of the configuration data using COM 115F DOCUMENT and a comparison
of the printout with the configured data is a strict requirement in the Licensing
Authority acceptance test.
The functions of both program packages are initiated by menu-driven operator prompting on the
programmer. The menus are linked to each other in a tree structure.
You can reach all the submenus using softkeys F1 to F7. F8 brings you back up through the higher
level menus. The HELP key gives you a detailed description of the functions of the keys.
1-2
Personal Computers
Siemens PC 16-11
Siemens PC 16-20
IBM ' XT and 100 % compatibles
IBM ' AT and 100 % compatibles
S5-115F Manual
EWA 4NEB 811 6149-02
Advertisement
Table of Contents
