Table of Contents
Advertisement
REMOTE CONTROL OPERATION
REMOTE CONTROL ACTIVATION
The remote is supplied with two Lithium cell CR2450 button batteries
already pre-inserted.
To activate pull the clear tab
on the digital display
E
Noting that this also occurs whenever a fresh set of batteries is installed.
Remove the batteries if the remote is not used for extended
periods. This will avoid damage from leaking batteries. If
leakage has occurred the remote will need to be replaced
NOTE
as the chemicals could be a risk if touched or ingested.
When the controller buttons are pressed the green indicator located in the
IR receiver window
F
that control inputs are being received, this indicates your remote control
is now working.
BUTTON FUNCTIONS, DISPLAY & OPERATION
For the remote control to be able to function, the appliance
Standby / ON button
Using the remote control to turn OFF the heater will place
NOTE
the heater into STANDBY mode.
The Standby / ON button
and ON modes.
The UP / DOWN buttons
output in five adjustment levels in fixed combination with two fan speeds.
FLAME HEIGHT AND FAN SPEED
The relationship between the flame height and fan speed
NOTE
are preset and can not be independently adjusted.
Flame Height
Fan Speed
Low
(2-speed only)
On initial start-up the appliance default flame height setting is 5 - High. The flame height may only
be adjusted after at least 30 seconds of operation.
NOTE
The remote control temperature sensor
temperature of where the remote control is currently located.
The remote controls digital display
the remote control is located in. It has a motion activated back light which will remain illuminated
for approximately 5 seconds after a movement is sensed or when a button is pressed. Frequent
illumination of the back light greatly reduces the remote control's operational battery life. To
increase battery life, ensure that unnecessary illumination of the display is avoided.
LOST, MISPLACED OR BROKEN REMOTE CONTROL
Breakage of the plastic housing could expose sharp edges, replace the remote if this occurs.
Avoid getting the remote wet as water entry will damage the remote.
NOTE
In the event that the remote control operation is not available, this appliance may then still be
operated in a limited capacity by using the heater's control panel.
NOTE
Refer to "Control Panel Operation" on page 9 for details on how to use the appliance in this
mode and the limitations of this form of operation.
Rinnai
, noting that 0X (OK) will briefly be shown
H
, to confirm that the activation was successful.
will flash and 'Beeps' will be emitted to confirm
must be in the "ON" condition.
A
switches the heater between the Standby
C
control the height of the flame and heat
D
1
2
3
Low
High
E
4
5
High
High
(located on the base of the controller) reads the
G
shows the temperature (in degrees Celsius) of the room that
10
F
C
D
E
G
RHFE 952/1253 OIM
H
Advertisement
Chapters
Table of Contents
Troubleshooting
