Operation Using Remote Control - Rinnai Arriva Operation And Installation Manual

Operation Using the remote Control
Lock Override
AM
PM
Temperature
Clock Set
Timer 1 Set ON OFF
Timer 2 Set
STANDBY
ON
Flame
Auto
O
Lock
When the heater is in Standby mode pressing the Standby/On button will
Turning the
start the ignition sequence and the LED will glow red to indicate that the
heater on
heater is operating.
Press the Standby/On button. This will turn off the unit and the LED will
Turning the
glow green to indicate appliance is in standby.
heater to
standby
Pressing the up and down buttons will change the preset temperature by
Adjusting the
increments of 1 °C.
temperature
Temperature will be displayed to confirm that the function has been
initiated.
The temperature can be preset to:
•
•
•
rinnai new Zealand Limited
STANDBY / ON
Stops and Operates the heater
Flame
CONTROL BUTTONS
Used to select the temperature,
Time
flame picture and adjust timers.
FLAME BUTTON
Sets the flame picture.
ON OFF
TIMER 1 BUTTON
Timer 1
Sets timer program 1.
TIMER 2 BUTTON
Timer 2
Sets timer program 2.
Override
OVERRIDE BUTTON
Manually overrides
Time current timer operation.
Set
AUTO OFF
Energy saving room temperature
TIME SET BUTTON
Sets clock and timers.
LOCK BUTTON
Locks out control to
prevent tampering.
L (Low)
16 °C ~ 26 °C (in 1 °C steps)
H (High)
BUTTON
remotely.
BATTERY
COMPARTMENT
COVER
control.
BATTERY COMPARTMENT
The remote control is powered by a pair of
To replace batteries simply unscrew the battery
compartment cover located on the back of the
remote control anti-clockwise, when installing
new batteries ensure that the correct polarity is
continuous combustion on low
combustion rate varies to maintain
selected temperature
continuous combustion on high
Arriva Operation and Installation Manual: 10343-E
12
BATTERIES AND
1.5V AAA batteries.
observed.
05-10