Remote Control - Rinnai Electric Fire Series Operation And Installation Manual

Remote control

Fuel bed downlight
Remote control batteries
KEEP BATTERIES OUT OF REACH
OF CHILDREN
WARNING
DO NOT:
• Mix old and new batteries
• Mix different types of batteries
• Heat or expose to flame
• Take apart
• Attempt to recharge alkaline batteries
• Use damaged batteries
Dispose of used batteries safely.
To avoid damage from leaking batteries,
remove batteries if controller is not going to be
used for a long periods.
Ensure that the two AAA batteries are inserted
into the remote control. The battery power
level is indicated by the column of bars to the
right side of the temperature display when in
standby mode. Five bars indicates the batteries
are full.
Remote control setup
Press and hold the Standby button until you
hear one beep, the remote is now connected
with the appliance.
6 | Electric fires operation and installation guide 17904-B
Preset mode
Standby
Minus button
Flame speed
Flame colour
Fuel bed colour
Timer mode
The remote control must be left in
the same room as the appliance as it
houses the thermostat that regulates
heat output
Plus button
Heater mode
Sound effect
Ambient lighting not available for NZ
Eco mode
Preset
Repeatedly press to cycle through the six
preset fire modes (plus three user defined
presets, if programmed).
Pr.1 Autumn campfire
Pr.2 Ember glow
Pr.3 Inferno
Pr.4 Noir
Pr.5
Fire and ice
User defined - personalised settings
Choose the flame colour
and the fuel bed downlight colour
have selected your desired combination:
• Press and hold the Preset button for three
seconds until the LCD displays FL.7.
• Press - and + buttons to select a user
defined number between 7-9.
• Press and hold the Preset button for three
seconds to confirm the preset.
= plus brightness level
1
Pr.6 Nebula
Pr.7 User defined
Pr.8 User defined
Pr.9 User defined
, the fuel bed colour ,
1 1
. Once you
1