Table of Contents
Advertisement
Make sure to touch the frame of the machine or use an anti-static grounding
6
product to discharge static electricity before you touch the DRAM SIMM
module.
Make sure to handle the DRAM SIMM module by its edges only. Do not
7
touch the surface of the DRAM SIMM module.
Hold the DRAM SIMM module at
8
a 30 degree angle, making sure
the corner notch is on the left side
and the metallic connectors are
pointed toward the DRAM SIMM
socket.
Gently push the DRAM SIMM
9
module into the socket, rotating the
module up until the module snaps
into the tabs on the socket and the
metal retaining clips lock the
module in place.
Replace the controller board cover and reinstall the screws.
j
Reconnect cables and plug in the power cord.
k
Turn on the machine power. The
l
machine detects the additional
memory. To verify whether the
additional memory was installed
correctly, you can print a System
Configuration page.
"Using the Control Panel" chapter
in this manual for instructions on
how to print a configuration page.
Refer to the
USING THE OPTIONS
4-7
Advertisement
Table of Contents
Troubleshooting
