Table of Contents
Advertisement
Bi-Direction Selection
You use this selection to specify whether you want the printer to send status
readback messages to the host computer. The options are as follows:
On - enables Bi-Direction mode
Off - disables Bi-Direction mode
The default setting is On.
NIC Personality Submenu
From the Host Interface menu, press the [
the [ ] key until "NIC Personality" displays on the Control Panel. You use this
submenu to specify the language interpreter for the network connection.
The NIC Personality submenu contains the following selections:
PCL
TIFF Raw Mode
Auto Sense
The Auto Sense, PS (PostScript ) and PS TBCP (Tagged Binary
Communications Protocol) options display only when the PostScript option is
installed. The default value is PCL. However, when the PostScript option is
installed, the default value is Auto Sense.
Note: When the NIC Personality is set to PS (PostScript ), the printer cannot
interpret PJL commands. If you use the PostScript driver, Parallel or NIC
personality should be set to Auto Sense.
USING THE CONTROL PANEL
] key and press the [ ] key or
PS (PostScript )
PS TBCP
2-23
Advertisement
Table of Contents
Troubleshooting
