Table of Contents
Advertisement
SETTING UP
Fan a stack of paper no thicker than 10 mm (0.4"), and place it in the tray.
Make sure to place the paper in the tray with the printing side face up. The
paper package indicates the printing side. You can also place a stack of up
to ten envelopes in the By-pass Tray.
When you use heavy paper, trans-
parencies, labels, or envelopes,
you must open the External Tray
or specify the output destination as
"Shift Tray Face-up" using your
application, your printer driver, or
the printer Control Panel.
Note: The Sift Tray is available only
when the optional Finisher
is installed.
Position the paper guides against
the stack of paper.
When printing envelopes, refer
to the "Using the Envelope
Feeder " in this manual.
Lower the green lever on the left side of the By-pass Tray to position the
paper stack.
Using the Control Panel, enter the size of the paper you placed in the By-pass
Tray.
Refer to the "Using the Control Panel" chapter in this manual for
information on how to enter paper sizes.
Print your job. Output is delivered to the output tray you selected using your
application or the printer driver.
Note: When you close the By-pass Tray, position the paper guides outside.
1-10
Advertisement
Table of Contents
Troubleshooting
