Table of Contents
Advertisement
Image Density Selection
You use this selection to set the Image density, or darkness, of the printed
output. The options are as follows:
Very Light
Light
Normal
Dark
Very Dark
The default value is Normal.
Note: You must print several pages before the changed Image Density value
becomes effective.
PM (Preventive Maintenance) Alarm Selection
You use this selection to specify whether you want the Control Panel to display
a message when the printer PCU, the Fusing unit and Rollers must be replaced.
The options are as follows:
On - displays a preventive maintenance message.
Off - dose not display a preventive maintenance message.
The default value is Off.
Reset Fusing Ut (Unit) Selection
This menu item displays only when the Fusing Unit must be replaced. After the
Fusing Unit is replaced, access this menu item and press the [Enter] key to
reset the counter. This counter, located in the printer engine, determines when
the Fusing Unit must be replaced again.
USING THE CONTROL PANEL
2-17
Advertisement
Table of Contents
Troubleshooting
