Parallel Operation Of Communication Interfaces - Siemens Sinamics S120 Function Manual

10.1.3

Parallel operation of communication interfaces

Cyclic process data (setpoints/actual values) are processed using interfaces IF1 and IF2.
The following interfaces are used:
● Onboard interfaces of the Control Unit for PROFIBUS DP or PROFINET
● An additional interface (COMM - BOARD) for PROFINET (CBE20) or CANopen (CBE10)
Parameter p8839 is used to set the parallel use of the Control Unit onboard interfaces and
COMM - BOARD in the SINAMICS system. The functionality is assigned to interfaces IF1
and IF2 using indices.
For example, the following applications are possible:
● PROFIBUS DP for control and PROFINET to acquire
● PROFIBUS DP for control and PROFINET for engineering only
● Mixed mode with two masters (the first for logic and coordination and the second for
● SINAMICS Link via IF2 (CBE20); standard telegrams and PROFIsafe via IF1
● Operation of redundant communication interfaces
Assignment of communication interfaces to cyclic interfaces
The two cyclic interfaces for the setpoints and actual values differ by the parameter ranges
used (BICO technology etc.) and the functions that can be used. The interfaces are
designated as cyclic interface 1 (IF1) and cyclic interface 2 (IF2).
With the factory setting p8839 = 99, the communication interfaces are permanently assigned
one of the cyclic interfaces (IF1, IF2), depending on the communication system, e.g.
PROFIBUS DP, PROFINET or CANopen.
The assignment to the cyclic interfaces can essentially be freely defined by user
parameterization for the parallel operation of the communication interfaces.
Drive functions
Function Manual, (FH1), 01/2012, 6SL3097-4AB00-0BP2
for insertion in the Control Unit as an option
actual values/measured values of the drive
technology)
10.1 Communication according to PROFIdrive
Communication
577