HEIDENHAIN iTNC 530 Service Manual page 79

Error message
Reciprocation feed
rate missing
Feed rate too fast
for graphics
Wrong sign
programmed
Material table not
found
Tool locked
Tool not defined
Tool axis is missing 391
Tool axis is missing 392
Tool axis is missing 393
Tool axis is missing 394
Tool axis is missing 395
Tool axis is missing 396
Tool axis is missing 397
Mirror image on
tool axis
Mirror image on
tool axis
July 2002
Error Cause of error
number
1856 In the Rough-Out cycle, the
reciprocation feed rate has not yet
been defined.
866 The feed rate is too high for the
program-run graphics to display tool
movement.
434 The programmed dwell time in the
Dwell Time cycle, Peck Drilling
cycle, or Tapping cycle is negative
(through Q parameter).
2226 The workpiece material table in
OEM.SYS was not found.
1789 The tool was locked.(e.g. after
breakage).
2345 You have called a tool that is not
defined in the tool table.
You programmed a positioning
block with tool radius compensation
without first calling a tool.
You programmed a single-axis
positioning block with tool radius
compensation without first calling
a tool.
You called a fixed cycle without first
activating a tool.
You programmed cycle 10
(Rotation,ISO: G73) without first
calling a tool. The tool call defines
which working plane the TNC
rotates.
You attempted to approach
a position using the positioning
logic, but did not first define the
working plain through a tool call.
You programmed the M function for
reducing the feed rate in the tool
axis, but did not call a tool first.
You called the TCH PROBE 0 cycle
(ISO: G55) without first calling a
tool.
389 You ran a TOOL CALL block (ISO:
T..) in which a mirrored axis is given
as tool axis.
390 In cycle 8 (Mirror Image, ISO: G28)
you defined the tool axis as a
mirrored axis.
Corrective action
Define the feed rate.
Select another screen layout.
Edit the cycle parameter.
Check the entry in the OEM.SYS
file and, if necessary, regenerate
the MAT.TAB file.
Check the tool and, if necessary,
change it or unlock it in the tool
table.
Add the missing tool to the tool
table.
Use another tool.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Cancel the mirror image before a
tool change.
If necessarya, change the tool axis
in the TOOL CALL block.
Edit the part program.
2 – 77