HEIDENHAIN iTNC 530 Service Manual page 32

Error message
Nominal speed
value too high %.2s
PWM triangular
signal error
DSP error %c
DSP error in axis
%.2s
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
Plane wrongly
defined
2 – 30
Error Cause of error
number
39 An excessively high nomial speed
value was calculated.
Analog axes:
Max. nominal speed value –10 V
Analog spindle:
Max. nominal speed value –10 V
Digital axes and spindle:
Max. nominal speed value = max.
motor speed
2887 Hardware error: Triangular signal
does not oscillate or it oscillates at
the wrong frequency
1122 Error in the power stage of the
displayed axis.
FF01 ..
F240 ..
2187 Error in the power stage of the
displayed axis.
313 The two axes of the circle end point
in a circle block (C, ISO: G2, G3,
G12, G13) differ from the axes in
the circle center block (CC, ISO:
I,J,K).
315 The tool axis is not perpendicular to
the plane in which the basic rotation
is active.
316 In a probing operation, the tool axis
active in the NC program is not
identical or parallel to the touch
probe axis, and the machine
parameter 7411 has the value 1
(current tool data remain in the part-
program block TCH PROBE, ISO:
G55).
317 In a circular block you programmed
the coordinates for the end point in
a main axis and its associated
parallel axis.
318 You programmed only one axis for
the arc end-point in a "Circle with
Radius" block (CR, ISO: G2, G3 with
R). You also either did not define a
tool axis or the programmed axis is
the tool axis.
319 In a CT block -(ISO: G6, G16) you
defined an axis that is not included
in the working plane.
320 Radius compensation in a circle
block is not possible if the circle lies
in a plane parallel to the tool axis
and a basic rotation or a
programmed rotation is active.
321 Radius compensation in a circle
block is not possible C (ISO: G2, G3)
if the starting point and end point do
not have the same two axes or
those axes are not parallel to the
axes of the circle center (CC, ISO:
I,J;K).
Corrective action
Inform your service agency.
Inform your service agency.
Exchange drive control board.
Inform your service agency.
Inform your service agency.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
Edit the part program.
HEIDENHAIN Service Manual iTNC 530