Restoring The Data - HEIDENHAIN iTNC 530 Service Manual

23.4.3 Restoring the data

Preparation Carry out the following steps:
 Connect the data transfer cable (serial or Ethernet) to your laptop and to the machine.
Configurations: See section "Data Interfaces" on page 269.

Start the data transfer software TNCremoNT on your laptop.
 For serial data transfer select the appropriate baud rate for the interface at the iTNC.
 In Extras/Configuration/Connection (or using the corresponding icon) set TNCremoNT to
LSV/2 (for serial data transfer) or to TCP/IP (for Ethernet transfer).

In Extras/Configuration/Connection (or using the corresponding icon)of TNCremoNT select
the COM interface and the baud drate for serial data tranfser. For Ethernet data transfer
enter the IP address of the iTNC.
Connection setup
and data
restoration

In the upper screen half (laptop contents), select the directory where you have stored
the backup file.
In this example C:\Backup Machine 1
 Doubleclick on the LST file to open it.
 Start the data transfer with menu item Run/Restore.
 Confirm the following warning with Ok.
 Confirm the message regarding automatic reset of control with Yes and continue
data transfer.
 After restoring the machine backup the control needs to be rebooted.
Now the machine operates as usual.
23 – 290

Establish connection with iTNC.
If this does not work, please check the connecting cable and the settings.
HEIDENHAIN Service Manual iTNC 530