HEIDENHAIN iTNC 530 Service Manual page 309

MP
MP1094
MP1095
MP1095.0
MP1095.1
MP1096
MP1097.x
MP1098.x
MP1099
MP1099.0
MP1099.1
MP1110.x
MP1140.x
MP1144.x
MP1150.0
MP1150.1
MP1150.2
MP1320
July 2002
Function and input
HSC filter
Input: 0: HSC filter inactive
0.1 to 166.0: Cutoff frequency for HSC filter
Nominal position value filter
Input: 0: Single filter
1: Double filter
In the Program Run, Full Sequence; Program Run, Single
Block; and Positioning With Manual Data Input operating
modes
In the Manual, Handwheel, Jog Increment and Pass Over
Reference Point operating modes
Tolerance for contour transitions
Input: 0: No nominal position value filter
0.001 to 3.000 [mm]
Max. permissible axis-specific jerk (single/HSC filter)
Input: 0.1 to 1000.0 [m/s or 1000°/s]
Max. permissible axis-specific jerk (double/HSC filter)
Input: 0.1 to 1000.0 [m/s or 1000°/s]
Minimum filter order
Input: 0 to 20
Minimum filter configuration for single filter (MP1095 = 0)
Minimum filter configuration for double filter (MP1095 = 1)
Standstill monitoring
Input: 0.0010 to 30.0000 [mm]
Threshold at which the movement monitoring goes into
effect.
Input: Analog axes: 0.030 to 10.000 [V]
Digital axes: 0.030 to 10.000 [1000 min]
Recommended: 0.030 [1000 min]
Motion monitor for position and speed
Input: Analog axes: without function
Digital axes: 0 to 99 999.999 [mm]
0: No monitoring
Delay time for deleting the nominal velocity value with the
erasable error message EXCESSIVE SERVO LAG IN <AXIS.>
Input: 0 to 65.535 [s] Recommended: 0
Time period for which the monitoring function is to remain
off after the fast PLC input defined in MP4130.0 is set.
Input: 0 to 65.535 [s]
0: Monitoring functions on
Recommended: 0.2 to 0.5
Minimum time period for which the monitoring functions
are to remain effective after expiration of the time from
MP1150.1.
Input: 0 to 65.535 [s]
Direction for traversing the reference marks
Format: %xxxxxxxxxxxxxx
Input: Bits 0 to 13 correspond to axes 1 to 14
0: Positive
1: Negative
Software
version and
behavior
280 474-07
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
25 – 307