HEIDENHAIN iTNC 530 Service Manual page 78

Error message
Program start
undefined
Program start
undefined
Program start
undefined
Program start
undefined
Err. in rated U of
motor %.2s
Subprogram does
not exist
Subprogram does
not exist
Incomplete cycle
was deleted
Illegal file name
Illegal file type
Uz %.2s error
Traverse definition
not defined
Datum shift not
permitted
Directory not empty 1848
Move to target
before starting
Use RESTORE
POS AT N
Feed rate is missing 161
2 – 76
Error Cause of error
number
422 The first positioning block in the
part program is a CHF block (ISO:
G24).
After a program interruption you
pressed GOTO to select a CHF
block (ISO: G24).
423 After a program interruption you
attempted to select a departing
block with GOTO.
424 At the beginning of the program you
activated a tilted working plane and
M114 at the same time.
426 When resuming a part program you
selected a CT block (ISO: G6, G16)
although a PLC positioning or a PLC
datum shift must be executed.
2926 Motor rated voltage outside of
permitted input range.
265 You defined a subprogram number
in Cycle 14 Contour Geometry (ISO:
G37) that does not exist in your
program.
266 You called a user cycle or a
subprogram in the definition of a
contour, a contour pocket or a cycle
contour train. However, the
corresponding file could not be
opened for reading.
2769 Informational message that the
TNC has erased an incomplete
cycle.
1807 Syntax error during file-name input.
1867 The function cannot be used for this
type of file.
2910 Incorrect entry in MP2190 (dc-link
voltage Uz).
2504 In a probing cycle you entered 0
for the traverse direction Q267.
453 Digitizing with contour lines:
Datum shift is active.
You attempted to erase a directory
that still contains files.
2666 You pressed the NC start button
before positioning manually (in
distance-to-go) to the target.
2500 You attempted a mid-program
startup by pressing GOTO block
number, although it is defined in
machine parameter 7680 that a
spline be inserted as connecting
element at radius-compensated
outside corners.
You did not program a feed rate.
Corrective action
Program at least two positioning
blocks before the CHF block.
After a program interruption, restart
at least two positioning blocks
before the CHF block.
After a program interruption, do
not resume the program at a
departing block.
M114 cannot be run while the
working plane is tilted.
Resume the program several
blocks before the CT block.
Inform your service agency.
Check entry in motor table.
Correct the subprogram number
in the cycle.
Program a subprogram with the
correct number.
Load the file again.
xxxx
Use no more than 16 characters
for file names.
Select another file type.
Inform your service agency.
Check entry in MP2190.
For Q267, enter either +1 (for
positive traverse direction) or -1
(for negative traverse direction).
Delete the datum shift.
First delete all files and
subdirectories stored in the
directory that you wish to delete.
Use the DELETE ALL function to
delete directories at once together
with their contents.
Position to the zero display
position, then press the NC start
key again.
Use the RESTORE POS. AT N
function to resume the program.
Edit part program, FMAX only
effective for block programming.
HEIDENHAIN Service Manual iTNC 530