HEIDENHAIN iTNC 530 Service Manual page 349

MP
MP7682
MP7683
July 2002
Function and input
Machine parameter with multiple function
Format: %xxxxx
Input: Bit 0 – Incremental block after TOOL CALL
0: with length compensation
1: without length compensation
Bit 1 – Reference value for calculating the preset
during datum setting
0: Actual value is calculated
1: Nominal value is calculated
Bit 2 – Traverse path of rotary axes with modulo
display
0: Positioning without passing over zero
1: Positioning on the shortest path
Bit 3 - Reserved, enter 0
Bit 4 - Tolerance of rotary axes with M128
0: With consideration of head dimensions
1: Without consideration of head dimensions
Executing pallet tables and NC programs
Format: %xxxxx
Input: Bit 0 - Nonfunctional
Bit 1 - Program Run, Full Sequence mode
0: During the start, a complete NC program is
run.
1: At the start all NC programs are executed up
to next pallet.
Bit 2 - Program Run, Full Sequence mode
0: As defined in bit 1
1: All NC programs and pallets up to the end of
the table are executed .
Bit 3 – When the end of the table is reached, the
process begins again with the first line.
0: Function is not in effect
1: Function is effective (bit 2 = 1)
Bit 4 – Editing the active pallet table
0: Active pallet table cannot be edited.
1: In the Program Run, Full Sequence and Program Run,
Single Block modes, the current pallet table can be edited.
Bit 5 – AUTOSTART soft key
0: Do not display soft key
1: Display soft key
Bit 6 – Display of pallet table and NC program
0: Both simultaneously in a split screen
1: Pallet table or NC program individually
Bit 7 - AUTOSTART function
0: AUTOSTART function by NC
1: AUTOSTART function by PLC
Software
version and
behavior
PLC
RUN
PLC
RUN
25 – 347