Checking The Electrodes; Glow Electrode - Henny Penny FlexFusion FGE 615 Service Instructions Manual

13.10 Checking the electrodes

Preparations •
Overview
a
X1
10
6
5
1
230V
230V

13.10.1 Glow electrode

Preparations •
INFORMATION
Troubleshooting
Remove the left side wall.
3 µA
N
a Ignition electronics A10 / A20
b Transformer T10 / T20
On the Service menu, select the Gas CO
Only begin troubleshooting when Gas request lights up green.
•
The transformer (b) is only supplied with voltage with active gas request. The
glow electrode can be checked visually through the sight glass on the gas
burner.
Check output voltage on the transformer.
The voltage is 24 V.
Check the current consumption of the glow electrode. This must
be at least 1.4 A.
Check fuse F1 on the transformer.
The fuse has blown.
Replace fuse. Repeat test and replace glow electrode if
necessary.
Check supply voltage at the transformer.
No voltage present = Check neutral conductor. Replace
transformer.
Voltage present = Replace ignition electronics.
Service instructions
Gas faults and error messages
b
24-28V, ~1,4A
F1 3,15A
c d
c Ionization electrode (flame
monitoring) B100 / B200
d Glow electrode F10 / F20
calibration and start.
2
79