Henny Penny FlexFusion FGE 615 Service Instructions Manual page 47

2. Screw in the adjusting screw for maximum output 10 mm (basic
setting).
3. Manually adjust the rated heat input for minimum power.
4. Manually adjust the rated heat input for maximum power.
a
b
Image: Adjusting screws on the burner
a Adjusting screw for minimum
output (TX40)
Manually adjusting the rated heat input for minimum power
1. Switch on the unit.
2. Open the CO2 setting display (see "Checking the settings").
3. Press the "START STOP" button.
4. Using the left knob, set the burner to low output ("LO").
The left display flashes "LO".
The centre display shows "CO2".
5. Use the right knob to select the first burner "-1-" (on models with
two burners).
The right display flashes "-1-".
6. Press the "START STOP" button.
The indicator light in the "START STOP" button flashes; the
burner starts.
The unit operates under partial load.
7. Press the Ready2Cook button.
The left display shows the current temperature in the cooking
chamber.
The center display shows the selected burner "-1-" (on models
with two burners).
The right display shows the current status of the burner
("G1F1").
8. Measure the exhaust gas values with an approved exhaust gas
measuring device once the operating temperature is reached.
To regulate the cooking chamber temperature, open the
cooking chamber door slightly.
Service instructions
Gas technology
b Adjusting screw for maximum
power (4 mm Allen key or 1.2 x
6.5 mm screwdriver)
47