Table of Contents
Advertisement
5500A
Service Manual
6-3. SC600 Specifications
These specifications apply only to the SC600 Option. General specifications that apply
to the Calibrator Mainframe (hereafter termed the Calibrator) can be found in Chapter 1.
The specifications are valid under the following conditions:
•
•
•
6-4.
Volt Specifications
Amplitude Characteristics
Range
Resolution
Adjustment Range
1-Year Absolute Uncertainty,
tcal ± 5 °C
Sequence
Square Wave Frequency Characteristics
Range
1-Year Absolute Uncertainty,
tcal ± 5 °C
Typical Aberration
within 4 µs from 50% of
leading/trailing edge
[1] Selectable positive or negative, zero referenced square wave.
[2] For square wave frequencies above 1 kHz, ± (0.25% of output + 40 µV).
6-6
The Calibrator is operated under the conditions specified in Chapter 1.
The Calibrator has completed a warm-up period of at least twice the length of time
the calibrator was powered off, up to a maximum of 30 minutes.
The SC600 Option has been active longer than 5 minutes.
Table 6-1. Volt Specifications
Volt Function
dc Signal
50 Ω Load
1 MΩ Load
0 V to ±6.6 V
0 V to ±130 V
Range
1 mV to 24.999 mV
25 mV to 109.99 mV
110 mV to 2.1999 V
2.2 V to 10.999 V
11 V to 130 V
Continuously adjustable
± (0.25% of
± (0.05% of
output +
output +
40 µV)
40 µV)
1-2-5 (e.g., 10 mV, 20 mV, 50 mV)
10 Hz to 10 kHz
± (2.5 ppm of setting)
< (0.5% of output + 100 µV)
Square Wave Signal [1]
50 Ω Load
1 MΩ Load
±1 mV to
±1 mV to
±6.6 V p-p
±130 V p-p
Resolution
1 µV
10 µV
100 µV
1 mV
10 mV
± (0.25% of
± (0.1% of
output + 40
output +
µV)
40 µV) [2]
Advertisement
Table of Contents
