Table of Contents
Advertisement
6-1. Introduction
This chapter contains the following information and service procedures for the
SC600 Oscilloscope Calibration Option functions.
•
Specifications
•
Theory of Operation
•
Calibration Procedures
•
Verification Procedures
•
Hardware Adjustments made after Repair
The calibration and verification procedures provide traceable results for all of the SC600
functions as long as they are performed using the recommended equipment. All of the
required equipment along with the minimum specifications, are provided in Table 6-15
under "Equipment Requirements for Calibration and Verification."
The calibration and verification procedures in this chapter are not the ones Fluke uses at
the factory. These procedures have been developed to provide you with the ability to
calibrate and verify the SC600 at your own site if necessary. You should review all of
the procedures in advance to make sure you have the resources to complete them. It is
strongly recommended that, if possible, you return your unit to Fluke for calibration and
verification.
Hardware adjustments that are made after repair, at the factory or designated Fluke
service centers, are provided in detail.
6-2. Maintenance
There are no maintenance techniques or diagnostic remote commands for the SC600 that
are available to users. If your SC600 is not installed or not receiving power, the
following error message appears on the display when you press a to access the
oscilloscope calibration menus.
IF THIS MESSAGE IS DISPLAYED, AND YOU HAVE THE SC600 INSTALLED in
your Calibrator Mainframe, you must return the Calibrator Mainframe to Fluke for
repair. If you wish to purchase the SC600, contact your Fluke sales representative.
SC600 Option
6
Introduction
OM030I.EPS
6-5
Advertisement
Table of Contents
