Table of Contents
Advertisement
I-8 Command Interpreter
Exit Command
Chart I-2
Exit Command
COMMAND
exit
Ethernet Commands
The following chart lists and describes the ether commands. Each of these
commands must be preceded by ether when you use them. For example, type
ether config to display information on the LAN configuration.
Chart I-3
Ether Commands
config
driver
cnt
ioctl
status
version
edit
load
mtu
accessblock
save
317517-A Rev 00
COMMAND
disp <name>
<ch_name> <command>
[arguments]
<ch_name>
<1:LAN>
<value>
<0:disable 1:enable>
DESCRIPTION
Ends the command interpreter session.
DESCRIPTION
Displays LAN configuration information.
Displays the Ethernet driver counters.
This command cannot be used
currently.
Shows the LAN status.
Displays the Ethernet device type.
Loads Ethernet (1:LAN) data from the
System Parameters Table.
Sets the Ethernet data Maximum
Transmission Unit.
Blocks Internet access.
Saves Ethernet data to the System
Parameters Table.
Advertisement
Table of Contents
