Table of Contents
Advertisement
20-14 WAN and Dial Backup Setup
Table 20-8 Menu 11.4: Remote Node Script Menu Fields
Set 1-6:
Enter a string to send out after the Expect string is matched.
Send
Remote Node Filter
20.10
Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set
the value to Yes. Press [ENTER] to open
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this
remote node and the Contivity 221 to prevent certain packets from triggering calls. You can specify
up to four filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that
spaces are accepted in this field. Please refer to the Filters chapter for more information on
defining the filters.
Figure 20-8 Menu 11.5: Dial Backup Remote Node Filter
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
317517-A Rev 00
Menu 11.5 - Remote Node Filter
0.0.0.0
.
Advertisement
Table of Contents
