Nortel Contivity 221 User Manual page 475

Chart I-5
IPSec Commands
COMMAND
contivitySplit
ContivityTime
CntbtNatState
debug <on|off>
exemptHost
display
load
active
sourceStart
sourceEnd
destStart
destEnd
save
ipPolicy activeNAT
add
delete
display
internal
list
load
local
Sets the time count between NAT states.
Turns the trace for IPsec debug information
on|off.
Use the exemptHost commands to configure
specific IP addresses that are not to be part of a
VPN tunnel.
Displays the exempt host settings.
<index> Loads an exempt host.
<Yes|No> Enables/disables an exempt host.
<IP address> Sets the exempt host's source start IP address.
<IP address> Sets the exempt host's source end IP address.
<IP address> Sets the exempt host's destination start IP
address.
<IP address> Sets the exempt host's destination end IP
address.
Saves an exempt host.
<Yes|No> Enables/disables NAT for an IP policy.
Adds an IP policy.
Removes an IP policy.
Displays the IP policies.
Displays the IP policies.
<policy Index> Loads an IP policy.
type <0:single|1:range| Sets an IP policy's local address type.
2:subnet>
Command Interpreter I-15
DESCRIPTION
Contivity 221 VPN Switch User's Guide