Mitsubishi Q64AD-GH User Manual page 108

5 UTILITY PACKAGE (GX Configurator-AD)
5 - 19
[Explanation of items]
(1) Contents of screen display
Setting item
Current value
Setting value
(2) Explanation of the command buttons
Current value display
Make text file
Start monitor /
Stop monitor
Execute test
Close
REMARK
The following describes an example where sampling process for the selection test
operation is changed to a 10-time averaging process specification.
(1) Change the Setting value field of CH
"Average number of times".
(2) Click and select the Setting value field of CH
of times/Move average/Time constant settings.
(3) After entering the average number of times, press the Enter key.
At this point, the value is not yet written to the A/D converter module.
(4) Hold down the Ctrl key and select the Setting value field where the value has
been entered by the operation performed in (1) to (3). Multiple items can also be
selected by performing mouse drag operation.
(5) Click Execute test to execute write operation.
Once writing has been completed, the value that was written will be displayed in
the current value field.
: The I/O signal or buffer memory names are displayed.
: The I/O signal status or current value of buffer memory are
monitored.
: Select or enter the data to be written during test operation.
The current value of the selected item is displayed.
(This is used to check text that cannot be displayed in
the current value field. However, in this utility package,
all items can be displayed in the display fields).
Creates a file consisting of the screen contents in text file
format.
Selects whether or not the current value fields are
monitored.
Performs a test of the selected item. To select more
than one item, select multiple items while holding down
the Ctrl key.
Closes the screen currently displayed and returns to
the previously displayed screen.
averaging process specification to
Average time/Average number
MELSEC-Q
5 - 19