Position Detection - Siemens SIMATIC ET 200S Operating Instructions Manual

Technological functions
Hide thumbs Also See for SIMATIC ET 200S:
Table of Contents

Advertisement

1Count24V/100kHz

2.8 Position Detection

2.8.2
Position Detection
Definition
In this mode, the 1Count24V/100kHz counts continuously starting from the load value:
• If the 1Count24V/100kHz reaches the high counting limit when counting up, and another
• If the 1Count24V/100kHz reaches the low counting limit when counting down, and
• The high counting limit is set at +2147483647 (2
• The low counting limit is set to –2147483648 (–2
Figure 2-34
Function of the Digital Input
For the "Function DI" parameter, select one of the following functions for the digital input:
• Input
• HW gate
• Latch function
• Synchronization
See also
Assigning Parameters for Position Feedback (Page 104)
Gate Functions for Position Detection (Page 89)
Latch Function (Page 92)
Synchronization (Page 95)
88
count pulse then comes, it will jump to the low counting limit and continue counting from
there without losing a pulse.
another count pulse then comes, it will jump to the high counting limit and continue
counting from there without losing a pulse.
Count Continuously with Gate Function
– 1).
31
).
31
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents