Example: Start 1Count24V/100Khz - Siemens SIMATIC ET 200S Operating Instructions Manual

2.3

Example: Start 1Count24V/100kHz

Introduction
These instructions guide you to a functioning application that will enable you to count the
switching operations of a contact and become familiar with and check the basic hardware
and software functions of the 1Count24/100kHz. The counting mode used in this example is
"Count continuously".
Requirements
The following requirements must be satisfied:
• You have commissioned an ET 200S station on an S7 station with a master.
• You must have the following:
Installation, Wiring and Fitting
1. Install and wire the TM-E15S24-01 terminal module (see Figure).
2. Connect the 1Count24V/100kHz to the terminal module (you will find detailed instructions
Figure 2-1
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
– A TM-E15S24-01 terminal module
– A 1Count24V/100kHz
– A momentary contact switch and the necessary wiring material
on how to do this in the
Terminal Assignment for the Example
ET 200S Distributed I/O System
1Count24V/100kHz
2.3 Example: Start 1Count24V/100kHz
Manual).
15