Wiring
6.8 Front connector for the I/O modules
6.8.4
Bringing the front connector into final position
Bring the front connector from the pre-wiring position into final position
1. Grip the front connector by the unlocking strap.
2. Pull on the strap until the front connector is released from its latched position.
3. Tilt the top section of the front connector and raise it slightly. The front connector slides
4. Push the front connector back into the module until it latches. The front connector is now
5. Swivel the front cover down into place. Depending on the space requirement of the cable
72
over the guide channel into its final position.
Figure 6-7
Bring the front connector from the pre-wiring position into final position
electrically connected with the module.
harness, various latch positions are possible, so that the required cable storage space
can grow as needed.
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01