Siemens SIMATIC ET 200S Operating Instructions Manual page 58

1Count24V/100kHz
2.7 Measurement Modes
The following figure illustrates the principle of continuous measurement using frequency
measurement as an example.
Figure 2-22
Gate Control
To control the 1Count24V/100kHz, you have to use the gate functions.
Isochrone Mode
In isochrone mode, the 1Count24V/100kHz accepts control bits and control values from the
control interface in each bus cycle and reports back the response in the same cycle.
In each cycle, the 1Count24V/100kHz transfers a measured value and the status bits that
were valid at time T
The measurement starts and ends at time T
58
Principle of Continuous Measurement (Frequency Measurement Example)
.
i
.
i
Operating Instructions, 02/2007, A5E00124867-05
Technological Functions