Assignment Of The Feedback And Control Interface For The Count Modes; Table 3-4 Feedback Interface (Inputs) - Siemens SIMATIC ET 200S Operating Instructions Manual

1Count5V/500kHz
3.6 Count Modes
3.6.10

Assignment of the Feedback and Control Interface for the Count Modes

Note
The following data of the control and feedback interfaces are consistent for the
1Count5V/500kHz:
Bytes 0 to 3
Bytes 4 to 7
Bytes 8 to 11 (modified user data interface)
Use the access or addressing mode for data consistency over the entire control and
feedback interface on your DP master (only for configuration using the GSD file).
Assignment Tables
The tables show the assignment of the feedback and control interface for the counting
modes.
Table 3-4 Feedback Interface (Inputs)
Address Assignment
Bytes 0 to 3 Count value or stored count value in the case of the latch function on the digital input
Byte 4 Bit 7: Short circuit of the encoder supply
Bit 6: Short circuit / wire break / overtemperature
Bit 5: Parameter assignment error
Bit 4: Short circuit / wire break / overtemperature
Bit 3: Short circuit / wire break / encoder signal
Bit 2: Resetting of status bits active
Bit 1: Load function error
Bit 0: Load function is running
Byte 5 Bit 7: Down direction status
Bit 6: Up direction status
Bit 5: Reserve = 0
Bit 4: DO2 status
Bit 3: DO1 status
Bit 2: Reserve = 0
Bit 1: DI status
Bit 0: Internal gate status
152
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
Designation
ERR_24V
ERR_DO1
ERR_PARA
ERR_DO2
ERR_ENCODER
RES_STS_A
ERR_LOAD
STS_LOAD
STS_C_DN
STS_C_UP
STS_DO2
STS_DO1
STS_DI
STS_GATE