Siemens SIMATIC ET 200S Operating Instructions Manual page 45

Modifying the Function and Behavior of Digital Outputs
You can modify the functions and behavior of the outputs during operation using the control
interface. The 1Count24V/100kHz deletes the outputs and accepts the values as follows:
• Function of digital outputs DO1 and DO2: If you change this function so that the
• Hysteresis: An active hysteresis (see How Hysteresis Works) continues to be active
• Pulse duration: The new pulse duration takes effect with the next pulse.
Technological Functions
Operating Instructions, 02/2007, A5E00124867-05
comparison condition is satisfied, the output is not set until after the next count pulse.
However, if hysteresis is active, the 1Count24V/100kHz does not make any changes at
the output.
following the change. The new hysteresis range is applied the next time the comparison
value is reached.
1Count24V/100kHz
2.6 Count Modes
45