Dust Collection - Grizzly T28048 Owner's Manual

Dust Collection

The Model T28048 has two dust ports. Both will
accept a 2 ⁄ " outside diameter dust hose and
1
2
a standard (2 ⁄ " diameter) shop vacuum hose
1
4
adapter.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust collection system.
Recommended CFM at Dust Port: 100 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
-24-
Connecting Dust-Collection System
to Router Table
1.
Fit a dust hose over one or both dust ports
(see Figure 31), and tightly secure with hose
clamp(s).
Bag
Dust
Port
Figure 31. Dust hoses attached to dust ports.
2.
Tug hose(s) to make sure it does not come
off.
Note: A tight fit is necessary for proper
performance.
Connecting Shop Vacuum to Router
Table
1.
Insert standard shop vacuum hose adapter
into one or both dust ports.
2. Tug hose(s) to make sure it does not easily
come off.
Note: A tight fit is necessary for proper
performance.
Model T28048 (Mfd. Since 06/17)
Fence
Dust
Port