Assembly - Grizzly T28048 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble router table:
1. Turn router table upside-down on a flat work-
ing surface, then attach (2) side frame sup-
port brackets to table with (4) M5 x 20 tap
screws, as shown in Figure 7. Make sure
hook-and-loop material faces inward.
Side Frame
Bracket
Table
Figure 7. Attaching side frame brackets to table.
2.
Attach rear frame to table with (3) M5 x 20
tap screws, as shown in Figure 8. Make sure
hook-and-loop material faces inward.
x 3
Figure 8. Attaching rear frame to table.
-16-
Hook-and-
Loop Material
x 4
Rear
Frame
Table
3. Attach front frame to table with (3) M5 x 20
tap screws, as shown in Figure 9. Make sure
hook-and-loop material side of frame faces
inward.
Front
Frame
Figure 9. Attaching front frame to table.
4.
Prepare (4) frame connector tubes by attach-
ing (8) outer tube clamps to connector tubes
with (8) M6-1 x 50 flat cap head screws
(see Figure 10).
5.
Prepare (8) inner tube clamps by inserting
(16) M6-1 hex nuts into accompanying slots
on inner tube clamps (see Figure 10).
Frame
Connector Tube
x 16
Figure 10. Example of a frame connector tube
and inner tube clamps prepared for attachment.
Model T28048 (Mfd. Since 06/17)
Hook-and-
Loop Material
x 3
Table
Outer
Tube Clamp
x 8
Inner
Tube
Clamp