Grizzly T28048 Owner's Manual page 20

13. Lay straightedge across mounting plate, plate
insert, and table surfaces in pattern shown in
Figure 14.
Table Surface
Figure 14. Pattern for aligning mounting plate.
14. Adjust set screws
so that ends of straightedge lay flat on
table surface at all positions of pattern
(see Figures 14 & 16).
Support
Bracket
Figure 15. Adjusting set screws to align
mounting plate with table surface.
Figure 16. Using straightedge to align mounting
plate with table surface.
-18-
Mounting
Board
Straightedge
(see Figure 15)
Mounting
Plate
Table Surface
Mounting Plate
15. Repeat Steps 13–14 as needed until mount-
ing plate is aligned with table surface.
IMPORTANT: Mounting plate and table sur-
face must be aligned evenly to ensure a
workpiece does not catch on mounting plate
or table surface and kickback.
16. Lift mounting plate out of table opening and
place it aside.
17. Use your finger to hold set screws in posi-
tion and hand-tighten hex nuts, as shown in
Figure 17.
Note: Set screws move easily when tighten-
ing. This step helps to keep them in position.
Support
Bracket
Figure 17. Hand-tightening hex nuts.
18. Fully tighten hex nuts, as shown in Figure 18.
This locks set screws in position.
Figure 18. Locking set screws in position.
Model T28048 (Mfd. Since 06/17)