Grizzly T28048 Owner's Manual page 19

6.
Attach assembled frame connector tubes to
front and rear frames with (8) M6-1 X 50 flat
head cap screws, as shown in Figure 11.
Prepared
Frame
Connector
Tube
Figure 11. Attaching assembled frame connector
tubes to front and rear frames.
7. Fasten prepared inner tube clamps to outer
tube clamps, as shown in Figure 12.
Note: DO NOT fully tighten tube clamp fas-
teners until all frame connectors are in place.
Figure 12. Attaching prepared inner tube clamps
to outer tube clamps.
Model T28048 (Mfd. Since 06/17)
x 8
Prepared
Inner Tube
Clamps
8.
Once all frame connector tubes are attached
to the front and rear frames, fully tighten all
tube clamp fasteners.
9. Attach (4) adjustable feet to threaded posts
on front and rear frames.
Note: Router table feet are used to level the
router table (see Router Table Leveling on
Page 23 for detailed instructions).
10. Turn router table upright.
11. Thread (12) M6-1 x 30 set screws half-way
through corner and side support brackets
(see Figure 13). Make sure hex ends of set
screws point downward.
IMPORTANT: DO NOT thread set screws
through middle hole of corner support brack-
et. These holes receive mounting plate cap
screws.
12. Thread (12) M6-1 hex nuts on set screws,
leaving space for set screw adjustment (see
Figure 13).
x 12
Figure 13. Set screws with hex nuts threaded
into support bracket.
13. Place mounting plate with plate insert inside
table opening on set screws.
Note: Make sure top surface of mounting
plate faces upward. (Top surface of mounting
has countersinks.)
Support
Bracket
-17-