Adjusting Fence Boards; Using Fence Board Spacers - Grizzly T28048 Owner's Manual

Adjusting
Fence Boards
The fence assembly on the Model T28048 has
infeed and outfeed fence boards. Each fence
board can be moved sideways up to 2" to increase
or decrease the space between the boards and
the router bit. The fence boards are held to the
fence assembly with low-profile shoulder screws
and knob bolts (see Figure 37). Use the knob
bolts to loosen or tighten the fence boards to the
fence assembly.
Knob
Bolt
Figure 37. Adjusting a fence board.
Model T28048 (Mfd. Since 06/17)
Using Fence Board
Spacers
The Model T28048 includes two fence board
spacers (see Figure 38) for edge jointing opera-
tions. The spacers allow you to offset the outfeed
fence board by ⁄ " or
1
32
T-slots on the front face of the fence assembly.
Each shim has a ⁄ " and
1
32
slot gives ⁄ " offset and the shallower slot gives
1
32
a ⁄ " offset.
1
16
⁄ "
1
16
Offset
⁄ "
1
32
Offset
Figure 38. Using spacers to offset outfeed fence
board.
To insert fence board spacers:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen router bit guard (see Adjusting
Router Bit Guard on Page 30).
3. Loosen outfeed fence board (see Adjusting
Fence Boards on This Page).
4. Slide fence board spacers into fence assem-
bly T-slots.
5.
Adjust and tighten fence boards (see
Adjusting Fence Boards on This Page).
6.
Adjust and tighten router bit guard (see
Adjusting Router Bit Guard on Page 30).
⁄ ". The shims slide into
1
16
⁄ " slot. The deeper
1
16
Fence
Board
Spacers
-29-