Table of Contents
Advertisement
Dust Collection
DO NOT operate Model G0604Z without
an adequate dust collection system. This
jointer creates substantial amounts of wood
dust while operating. Failure to use a dust
collection system can result in short and
long-term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
-22-
To connect a dust collection hose:
Fit 4" dust hose over dust port on left side
1.
of cabinet and secure in place with a hose
clamp (see Figure 20).
Tug hose to make sure it does not come off.
2.
Note: A tight fit is necessary for proper
performance.
Figure 20. Example of dust hose connected to
dust port.
Model G0604Z (Mfd. Since 02/24)
Advertisement
Table of Contents
