Grizzly T28048 Owner's Manual page 23

4.
Lift mounting plate out of table opening and
lay it bottom-side-up on a protected working
surface.
Note: Make sure surface is clear of anything
that may scratch top surface of mounting
plate.
5. Place router
(see Figure 25), taking into account access
to router controls.
6.
Use erasable marker to mark center curve of
router base, router base plate, and mounting
plate as shown in Figure 25.
Figure 25. Marking center curve of router base,
router base plate, and mounting plate.
7. Remove base
(see Figure 26).
Note: Make sure to keep fasteners used to
secure base plate to router.
Figure 26. Example of removing base plate from
router.
Model T28048 (Mfd. Since 06/17)
on mounting plate
Mounting
Plate
plate from router
Router
Base Plate
8.
Center router base plate on mounting plate
(see Figure 27), keeping marks made in
Step 6 aligned. To center router base plate,
position it so distance edge-to-edge on right
and left side are equal, and distance edge-to-
edge on top and bottom are equal.
Note: It may be necessary to slightly adjust
alignment if holes in router base plate over-
lap or are too close to starter pin holes (see
Figure 27).
9.
Use router base plate as template to mark
holes on bottom-side surface of mounting
plate, as shown in Figure 27.
Mounting
Plate
Router
Base
Plate
Figure 27. Marking holes on mounting plate.
10. Use center punch to score marks made in
Step 9.
Starter
Pin Hole
-21-