Test Run - Grizzly T28048 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Model T28048 (Mfd. Since 06/17)
To test run router table:
1. Clear all setup tools away from router table.
2. Make sure router table paddle switch is set to
OFF.
3. Make sure router power cord is connected to
switch power cord receptacle.
4.
Connect switch power cord to power supply.
5. Reach into dust-collection bag and turn rout-
er ON.
6. Using paddle switch, turn router table ON,
verify router powers up, and then turn router
table OFF.
7. Remove switch-disabling key, as shown in
Figure 32.
Figure 32. Removing switch key from paddle
switch.
8. Try to start router with paddle switch. The
router should not start.
—If router does not start, switch disabling
feature is working as designed.
— If router does start, immediately stop
router. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
Congratulations! The test run is complete.
The router table is ready for operation.
-25-