Grizzly T28048 Owner's Manual page 40

8. Repeat Steps 6–7 as needed until mounting
plate is aligned with table surface.
IMPORTANT: Mounting plate and table sur-
face must be aligned evenly to ensure a
workpiece does not catch on mounting plate
or table surface and kick back.
8.
Lift mounting plate out of table opening and
place it aside.
9.
Use your finger to hold set screws in posi-
tion and hand-tighten hex nuts, as shown in
Figure 54.
Note: Set screws move easily when tighten-
ing. This step helps to keep them in position.
Support
Bracket
Figure 54. Hand-tightening hex nuts.
10. Fully tighten hex nuts, as shown in Figure 55.
This locks set screws in position.
Figure 55. Locking set screws in position.
-38-
11. Attach router to mounting plate (refer Steps
13 & 14 on Page 22).
12. Secure mounting plate and router to router
table (refer to Steps 15-17 on Page 22).
13. Attach fence assembly to router table (refer
to Step 21 on Page 19).
14. Make sure fence boards are parallel to table
T-slot (see Page 28).
Model T28048 (Mfd. Since 06/17)