Dust Collection - Grizzly G0931 Owner's Manual

Dust Collection

This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.
Minimum CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Model G0931 (Mfd. Since 02/21)
To connect dust collection system to machine:
1. Attach dust shoe bracket end to spindle
motor and secure with (1) M5-.8 x 45 cap
screw and (1) M5-.8 hex nut (see Figure 16).
x 1
Dust Shoe
Bracket End
Figure 16. Attaching dust shoe bracket.
2. Fit 4" dust hose over dust port and secure in
place with hose clamp (see Figure 17).
Figure 17. Tightening dust hose clamp.
3.
Tug hose with light/medium force to make
sure it does not easily come off.
Note: A tight fit is necessary for proper
performance.
Spindle Motor
Dust Port
-21-