Aligning Mounting Plate - Grizzly T28048 Owner's Manual

Aligning Mounting
Plate
To ensure a workpiece does not catch on the
mounting plate and cause kick back, the mounting
plate must be aligned evenly with the top of table.
Tools Needed:
Hex Wrench 3mm .............................................. 1
Hex Wrench 4mm .............................................. 1
Open-end Wrench 10mm .................................. 1
Straightedge 24" ................................................ 1
To align mounting plate:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove fence assembly from router table
and and table insert from mounting plate
(see Locking/Unlocking Table Inserts on
Page 30 for detailed instructions).
3.
Remove router from mounting plate.
4.
Remove (4) flat head cap screws that secure
mounting plate to table.
5.
Loosen (12) hex nuts that lock (12) set
screws (see Figure 50).
Mounting
Plate
Figure 50. Loosening hex nuts.
Model T28048 (Mfd. Since 06/17)
Qty
Support
Bracket
6. Lay straightedge across mounting plate, plate
insert, and table surfaces in pattern shown in
Figure 51.
Table Surface
Figure 51. Pattern for aligning mounting plate.
7.
Adjust set screws
so that ends of straightedge lay flat on
table surface at all positions of pattern
(see Figures 51 & 53).
Support
Bracket
Figure 52. Adjusting set screws to align
mounting plate with table surface.
Figure 53. Using straightedge to align mounting
plate with table surface.
Mounting
Board
Straightedge
Figure 52)
(see
Mounting
Plate
Table
Surface
Mounting
Plate
-37-