Leveling Router Table; Connecting Power Cords - Grizzly T28048 Owner's Manual

Leveling
Router Table
To reduce risk of injury from accidental
contact with spinning router bit, ALWAYS
make sure router table is placed on a flat,
clean surface and then leveled before router
operations.
The feet on the Model T28048 are adjustable and
used to level the router table. This keeps it from
rocking during routing operations.
To level router table:
1.
Place router on a flat, clean surface.
2.
Loosen (4) M10-1.5 hex nuts on router table
feet.
3.
Lay a level across router table surface in pat-
tern shown in Figure 30.
4.
Adjust router table feet to make sure level
lays flat on router table surface at positions
shown in Figure 30.
Table Surface
Figure 30. Pattern for leveling router table.
5.
Tighten hex nuts to secure router table feet.
Model T28048 (Mfd. Since 06/17)
Mounting
Plate
Level
Connecting
Power Cords
DO NOT connect router table power cords
to any power supply other than that listed in
Electrical section of this manual.
Electrocution, fire, shock,
or
may occur if machine is
not properly grounded
and connected to power
supply.
Connection between router power cord and
switch power cord must be made outside
the dust-collection bag, where it is free of
dust and debris to reduce risk of fire.
The Model T28048 includes an ON/OFF paddle
switch with disabling key. This allows you to start
and stop your router without the need to reach
into the dust-collection bag for the router ON/OFF
control. Two power cords are connected to the
switch. The shorter power cord has a 5-15 recep-
tacle and connects to the router power cord. The
longer power cord has a 5-15 plug and connects
to a 110V power supply circuit.
To connect router and router table to power:
1.
Make sure router table paddle switch is set to
OFF.
2.
Feed router power cord through opening
at bottom of dust-collection bag, then close
opening.
3. Insert router power cord into 5-15 receptacle
on router table switch power cord.
4.
Insert 5-15 plug on router table switch power
cord into matching power supply outlet.
equipment damage
-23-