Assembly - Grizzly T33959 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
T33959/T33960: Attach column assembly
1.
to base with (4) M10-1.5 x 40 hex bolts (see
Figure 18).
T33961: Attach column assembly to base with
(4) M12-1.75 x 40 hex bolts (see Figure 18).
Column
Assembly
Figure 18. Column assembly attached to base
(T33961 shown).
Remove Phillips head screw from belt cover
2.
knob, then use screw to install knob on belt
cover, as shown in Figure 19.
Model T33959/60/61 (Mfd. Since 08/23)
x 4
Base
With help, carefully lift headstock and slide it
3.
onto column (see Figure 19).
Headstock
Figure 19. Belt cover knob installed and
headstock placed on column (T33960 shown).
Use measuring tape or ruler to find and mark
4.
center of base, then suspend plumb bob from
center of headstock spindle over base, as
shown in Figure 20.
Figure 20. Example of aligning headstock with
center of base.
Adjust headstock on column until it is directly
5.
over center of base, as indicated by plumb
bob, then secure headstock by tightening (2)
set screws shown in Figure 19.
Belt Cover
Knob
Plumb
Bob
-21-