Assembly - Grizzly G0958 Owner's Manual

Assembly

Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1. G0958 Only: Remove (4) support rods con-
necting infeed/outfeed tables to base. These
are for shipping only and must be removed
before machine can be used.
2. G0958 Only: Install fence assembly (see
Figure 10) on back of machine frame with (2)
M5-.8 x 20 cap screws.
Fence Assembly
Figure 10. Fence assembly installed on machine
frame (G0958).
-22-
3. G0959 Only: Install fence assembly (see
Figure 11) on back of machine frame with (2)
M6-1 x 16 button head cap screws and 6mm
flat washers.
Figure 11. Fence assembly installed on machine
4. Install dust port housing beneath outfeed
table (see Figure 12), and secure by insert-
ing interlock keys in slots on each side of
table.
Note: Machine will not start if keys on dust
port housing are not installed in slots on
outfeed table.
Outfeed
Table
x 2
Dust Port
Housing
Figure 12. Dust port housing installed beneath
Fence Assembly
frame (G0959).
Interlock Key (1 of 2)
outfeed table.
Model G0958/G0959 (Mfd. Since 05/22)
x 2