Availability - Siemens SIMATIC S5-115U User Manual

Simatic s5 series cpu 941-7ub11 cpu 942-7ub11 cpu 943-7ub11 and cpu 943-7ub21 cpu 944-7ub11 and cpu 944-7ub21
Table of Contents

Advertisement

Reliability, Availability and Safety of Electronic Control Equipment
14.1.1 Failure Characteristics of Electronic Devices
The failure-rate-versus-time curve can be broken down roughly into three periods of time.
Early
Failures
(1)
0
10
Figure 14-1. Failure Characteristics of Electronic Devices ("Bathtub" Curve)
(1) Early failures are caused by material and manufacturing defects and the failure rate falls
steeply during the initial period of operation.
(2) The random failure phase is characterized by a constant failure rate. Provided the systems are
used in accordance with the specifications, only random failures occur during this period.
This period covers the normal behaviour of system components and is the basis for the
calculation of all reliability parameters.
(3) The failure rate increases with time. Wear-out failures become more frequent, indicating that
the end of the useful life is approaching. The transition to this phase is gradual. There is no
sudden increase in the failure rate.
14.1.2 Reliability of SIMATIC S5 Programmable Controllers and Components
A very high degree of reliability can be achieved by taking the following extensive and cost-
intensive measures during the development and manufacture of SIMATIC S5 systems:
The use of high-quality components;
Worst-case design of all circuits;
Systematic and computer-controlled testing of all components supplied by subcontractors;
Burn-in of all LSI circuits (e.g. processors, memories etc.);
Measures to prevent static charge building up when handling MOS ICs;
Visual checks at different stages of manufacture;
In-circuit testing of all components, i.e. computer-aided testing of all components and their
interaction with other components in the circuit;
Continuous heat-run test at elevated ambient temperature over a period of several days;
Careful computer-controlled final testing;
Statistical evaluation of all failures during testing to enable the immediate initation of
suitable corrective measures.
14-2
Random
Failures
(2)
4
10
Wear-out
Failures
(3)
t in h
6
S5-115U Manual
EWA 4NEB 811 6130-02b

Advertisement

Table of Contents
loading

Table of Contents