Controller - Sega Let’s Go ISLAND! Owner's Manual

CONTROLLER

1
● This work should be performed by site maintenance personnel or other skilled
professionals. Work performed by non-technical personnel can cause a severe
accident such as an electric shock.
● When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
● Exercise due caution in performing soldering procedures. If soldering iron is
handled carelessly, there could be fires or burns.
● Proceed very carefully when heating thermal contraction tube. Careless
operations can result in fires or burns.
● Be careful not to damage the wires. Damaged wires may cause electric shock or
short circuit or present a fire risk.
● Do not touch undesignated places. Touching places not designated can cause
electric shock or short circuit.
● Stand back from the cabinet when restoring power after maintenance has been
completed. The seat will automatically undergo initialization operation when
power is restored. Failure to move away from the product could result in an
accident such as a collision or fall.
● When fastening plastic parts, be careful not to tighten screws and nuts
excessively. Otherwise parts may be damaged, resulting in injuries from
fragments, etc.
● Be careful not to get hand or finger caught when removing or attaching the
parts.
● Handle parts inside the Controller very carefully. Be especially careful to avoid
damage, deformation or loss of these parts. If any one of these parts is lost or
defective, it can result in damages and/or faulty operations.
Be sure to perform volume's move value setting in the CONT CALIBRATION
SETTING screen in the GAME TEST MODE after replacing or adjusting the Volume.
(See 11-.)
59
CONTROLLER
13