Handling Precautions - Sega Let’s Go ISLAND! Owner's Manual

HANDLING PRECAUTIONS

1
When installing or inspecting the machine, be very careful of the following points and pay attention to ensure that
the player can enjoy the game safely.
Non-compliance with the following points or inappropriate handling running counter to the cautionary matters
herein stated can cause personal injury or damage to the product.
● Proceed with checks and tasks as indicated in these instructions. If instructions
are not followed, or if tasks and/or checks are neglected, an electric shock or
other very serious accident, even fatal accident, can occur. Also, customers
could be injured while operating the product.
● Before performing work, be sure to turn the power off. Performing the work
without turning the power off can cause an electric shock or short circuit. In the
case work should be performed in the status of power on, this manual always
states to that effect.
● To avoid an electric shock, do not plug in or unplug with a wet hand.
● Do not expose power cables or earth (ground) wires on the surface, (floor,
passage, etc.). If exposed, the power cables and earth (ground) wires are
susceptible to damage. Damaged cords and wires can cause an electric shock or
short circuit. Wherever wiring has been laid out on a floor surface, use a wiring
protection cover.
● To avoid causing a fire or an electric shock, do not put things on or damage the
power cables.
● When, or after installing the product, do not unnecessarily pull the power cable.
If damaged, the power cable can cause a fire or an electric shock.
● In case the power cable is damaged, ask for a replacement through where the
product was purchased from or the office listed in this manual. Using the cord
as is damaged can cause fire, an electric shock or leakage.
● Be sure to perform grounding appropriately. Inappropriate grounding can cause
an electric shock.
● When inserting or removing a connector, always hold it by its main part. If
you hold it by anything else while doing so, the connections between wire and
connector terminal fixtures could be damaged; and there could be a short circuit
or fire.
● Be sure that connections such as IC board are made properly. Insufficient
insertion can cause an electric shock.
● When connecting a connector, check the direction carefully. Connectors must
be connected in only one direction. If indiscriminate loads are applied in making
connections, the connector or its terminal fixtures could be damaged, resulting
in electrical shock, short circuits or fires.
● Be careful not to damage the wires. Damaged wires may cause electric shock or
short circuit or present a fire risk.
● Do not touch undesignated places. Touching places not designated can cause
electric shock or short circuit.
HANDLING PRECAUTIONS
1
1