Assembling Check - Sega Let’s Go ISLAND! Owner's Manual

- ASSEMBLING CHECK

Use TEST MODE to check whether or not the product has been assembled correctly and whether or not everything
is normal with the RINGWIDE.
1
Turn on the power switch.
2
The fluorescent lamps at the bottom of the billboard and the back of the rear cabinet light up.
3
The RINGWIDE startup image appears on the screen.
4
The initialization screen appears on the screen. Take proper precautions since the initialization operation
will begin.
5
When seat initialization is complete, the seat moves to a horizontal position and the Advertise screen
appears.
6
Press the TEST Button to enter TEST MODE and bring up the SYSTEM TEST MENU screen. (See
Chapter 10.)
7
MONITOR TEST screen
Select "MONITOR TEST" in SYSTEM TEST MODE to bring up the MONITOR TEST screen.
The monitor is shipped from the factory pre-adjusted, but you may use the MONITOR TEST screen to
determine whether it needs to be re-adjusted. If adjustment is needed, refer to the RINGWIDE service
manual for instructions on adjusting the monitor.
8
Select "GAME TEST MODE" in SYSTEM TEST MODE to enter GAME TEST MODE. (See 11-1.)
9
The initialization screen appears on the screen. Take proper precautions since the initialization operation
will begin.
10
INPUT TEST screen
Select "INPUT TEST" in GAME TEST MODE to bring up the INPUT TEST screen, allowing you to test
input devices to verify they are working properly. (See 11-3.)
11
OUTPUT TEST screen
Select "OUTPUT TEST" in GAME TEST MODE to bring up the OUTPUT TEST screen, allowing you
to test output devices such as controllers, lamps, and LEDs to verify they are moving and lighting up
properly. (See 11-4.)
12
CONT CALIBRATION screen
Select "CONT CALIBRATION SETTING" in GAME TEST MODE to bring up the CONTROLLER
CALIBRATION screen, allowing you to calibrate controllers. Select "CALIBRATION START" and swing
the 1P and 2P controllers all the way up, down, left, and right to calibrate them. (See 11-6.)
13
After all checks are finished, be sure to play a game before putting the product into operation to check for
gameplay problems and determine whether further adjustments are needed.
ASSEMBLY AND INSTALLATION
29
6