Software Installation - Sega Let’s Go ISLAND! Owner's Manual

2
ASSEMBLY AND INSTALLATION

- SOFTWARE INSTALLATION

PLEASE NOTE THAT THIS PRODUCT IS DELIVERED WITH SOFTWARE PRE-INSTALLED.
● When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
● The following explanation assumes that the product has been assembled
properly as explained above. If there is an error or if the product operates in a
manner other than as indicated below, turn off the power supply immediately.
6
Failure to do so may result in a fire or electrical shock.
● Looking directly at the laser of the DVD DRIVE may cause eye injuries. Do not
look inside the DVD DRIVE.
● Check the surrounding area before turning on the power. The product will
perform the initializing operation automatically after the power is turned on. If
there are people near it, they could be struck or knocked over when the seat
moves to the left and right.
CAUTIONS REGARDING USE OF DVD DRIVE AND DVD WIRE
● Do not use or store the DVD DRIVE or DVD wire in any of the following locations, as
this may result in serious damage.
[Do not use or store in these locations]
- Anywhere which may vibrate or shock the equipment
- In direct sunlight
- In damp or dusty places
- In places with a sharp change in temperature
- Close to anything that gives off heat (a heater, etc.)
- Close to anything with a strong magnetic field (magnets, monitor, speakers, radio, etc.)
- Anywhere that is likely to get wet (kitchen, etc.)
- Anywhere with a slope or incline
- Anywhere with corrosive gas in the air (chlorine, hydrogen sulfide, ammonia, sulfur
dioxide, etc.)
- Anywhere with strong static electricity
[Do not use in these locations]
- Close to anything that is highly retentive of heat (carpet, sponge, cardboard, etc.)
- Anywhere that blocks the DVD DRIVE air vent.